Bimba OLE Manual de usuario descargar pdf (Pagina 9)

b. Connect the DC power supply to the driver -- Do not

apply power

I. Make sure the power supply is not on. Connect V+ and V- from the

power supply to the V+ and V- terminals of your driver.

II. Ensure a proper earth ground connection by

using the screw on the left side of the chassis.

All system components must be grounded to

a single point common earth ground.

If using an external fuse, we recommend the

following in-line with the V+ connection:

DRV-4: 3AG, 4 amp (Littlefuse 313004P)

DRV-8: 3AG, 6.25 amp (Littlefuse 3136.25P)

c. Connect the motor to the driver

orange+blk/wht

black+org/wht

red+yel/wht

yellow+red/wht

A+ A- B+ B-

Connect OLE or OLET eight lead motors in parallel, as shown below. If us-

ing a motor from another source, please refer to your motor specs for wiring

information. A motor wiring diagram is shown in Figure 1.

Warnings:

• Do not install drive where ambient air is more than 104° F.

• Do not install drive where there is no air ow

• Do not install drive where drive can get wet.

• Do not install drive where electrically conductive material can

fall on the driver.

• Drives must be mounted at least one-half inch apart.

Warning: Observe proper polarity when connecting wires.

Warning: Never connect or disconnect the motor when power is

applied.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Sin comentarios

Bimba OLE Manual de usuario Pagina 9