Bimba OLE Manual de usuario

Original Line Electric Actuator, Electric Thruster, Motor, and Driver Quick Start ManualPlease read this manual carefully before implementing your O

e. Adjust running and idle currentd. Set rotary switch for the motor selected(This is normally set by the factory for the motor specied.)Switch 1 and

Switch 3 chooses between two load inertia ranges. This information is used in the anti-resonance conguration.f. Set load inertiag. Select step resolu

STEP+STEP–DIR–EN+EN–FAULT+FAULT–DIR+h. Apply power and run self testThe DRV-4 and DRV-8 have built in Self Test functions. When switch 8 is moved to t

Connection Examples: STEP & DIRConnecting to indexer with Sourcing OutputsSTRCOM DIR-DIR DIR+STEP-STEP STEP+Indexer with Sourcing Outputs Conne

Connecting another drive to EN(When output closes, input closes)Connecting an NPN Type Proximity Sensor to an input(When prox sensor activates, input

j. FAULT outputThe DRV drives feature a digital FAULT output. This output closes to signal a fault condition.This output can be used to drive LEDs, re

k. Set step pulse typeMost indexers and motion controllers provide motion commands in the “Step and Direction” format. The Step signal pulses once for

m. Technical specications15AmplierDigital MOSFET. 20 kHz PWM. Suitable for driving two phase and four phase step motors with four, six or eight lead

n. Alarm codesIn the event of a drive fault or alarm, the green LED will ash one or two times, followed by a series of red ashes. The pattern repeat

17Troubleshooting Guide and FAQProblem: Actuator does not move when step motor is energized.Solution: Step motor windings may be shorted. Use an Ohmme

Scope of this manualThis instruction manual supports Bimba standard components only. If special motion control compo-nents, including but not limited

18Inspect the motor and rotate the shaft when the motor is not connected. If you feel any rubbing or there are any dents on the motor, there is prob-a

Problem: The motor does not move when a step signal is sent to the drive. Solution: If the enable input is on (low with respect to a 5-24 volt signal)

Bimba Manufacturing Company Monee, Illinois 60449-0068 Tel: 708.534.8544Tech Support: 800.44BIMBA Fax: 708.235.2014 [email protected] www.bimba.comOLE

Contents1. Actuator-only Models ... 2 Installing your motor2. Actuator and Motor M

Congratulations on purchasing an Original Line Electric actuator from Bimba. Our OLE and OLET actuators are designed, built, and tested to provide the

Table 2Actuator Allen Key Torque75 9/64" 12 in-lbs.150 9/64" 12 in-lbs.350 5/32" 35 in-lbs.c. Mount motor to actuator, slip shaft into

42. Actuator and Motor Models All Bimba step motors use the same 8-wire wiring color code convention, as shown below. .Table 4Incremental Enco

Table 5Pin No. Wire Color Function1 Yellow Channel A2 Yellow/White Channel A-3 Blue Channel B4 Blue/White Channel B-5 Orange Index6 Orange/White Index

You will need:Motor & Power SupplyConnectorRun Current, Idle CurrentSteps/rev, Inertia, Self TestInput & OutputSignalsMotor SelectorStatus LED

b. Connect the DC power supply to the driver -- Do not apply powerI. Make sure the power supply is not on. Connect V+ and V- from the power supp